10.6 Sewing
The sewing operation can be controlled either by push button or with
the keys “OK” and “ESC” at the control panel.
Sew ing w ith the push button
With the push button the clamps can be controlled and the sewing
operation started. According to the adjustment in the service menu
(see service instructions) the function is different.
1. Adjustment (Standard)
–
Key 1: The clamps are opened or closed respectively.
–
Key 2: The sewing operation starts when the clamps are closed.
2. Adjustment
–
Key 1: The clamps are opened or closed respectively.
–
Key 2: If the clamps are not lowered, they will be lowered now. The
sewing operations starts.
Quick stop while sewing
- Press key 1 or 2. The sewing operation stops.
- Press key 1 for aborting the sewing operation.
- Press key 2 for continuing the s ewing operation.
Sew ing w ith the keys at the control panel
–
Load the fabric.
–
Press key “OK” once. The clamps close.
–
If you wish to open the clamps again, press key “ESC”.
–
When the sewing operation is to be s tarted, actuate k ey “OK”
anew. The buttonhole is sewn.
After the sewing operation the automat moves to the loading
position again.
Quick stop while sewing
-Pressthe“OK”-key or the “ESC”-key. The sewing operation stops.
-Pressthe”ESC”-key for aborting the sewing operation.
-Pressthe“OK”-key for continuing the sewing operation.
Sew ing w ith pedal (optional equipment)
The pedal is a two-step pedal without backpedal function.
–
When pedalling the first step the clamps are closed. The clamps
open again when the first step is released.
–
When pedalling the second step the sewing operation starts. The
pedal can be released as soon as the sewing operation has
started.
Quick stop while sewing
- Step on the pedal. The sewing operation stops.
- Step on the pedal once again for aborting the sewing operation.
- The sewing cannot be continued with the pedal! For continuing the
sewing operation you have to use the control panel or the push button.
Taking off the finished w orkpiece
–
In order to take off the finished workpiece, draw the bottom thread
and the gimp under the thread clamp 2. Pull both threads along the
knife 1 from the right to the left.
The threads are cut.
1
29
12
To Next Page
Loading...
Need help?
General
