Safety
Instructions for use DAC basic/classic - DAC eco plus - OP4X00 - 00.0 - 04/2024 9
3 Safety
This chapter contains basic information for your safety.
Read the instructions carefully before setting up or operating the
control. Be sure to follow the information in the safety instructions.
Failure to do so can result in serious injury and property damage.
3.1 Basic safety instructions
The control DAC basic/classic - DAC eco plus - OP4X00 may
only be used as described in these instructions.
The instructions should be available at the control's location at all
times.
Work on live components is prohibited.
The control was built and tested in compliance with all valid
ordinance and safety regulations, and left the factory in proper
working order.
The control will only work safely and reliably when the control is
used as intended ( 4.4 Proper use, p. 18).
Before leaving the workplace:
• Switch off the control
• Wait until the machine stops
• Wait until the LEDs go out
Obligations
of the operator
Follow the country-specific safety and accident prevention regu-
lations and the legal regulations concerning industrial safety and
the protection of the environment.
All warnings and safety signs on the control must always be in
legible condition and may not be removed. Missing or damaged
labels must be replaced immediately.
To Next Page
Loading...
Need help?
General
