Safety
Instructions for use DAC basic/classic - DAC eco plus - OP4X00 - 00.0 - 04/202410
Requirements
to be met by
the personnel
The control may only be set up by specialists. Specialists are
persons with electronics and mechanical training.
The following work may only be performed by specialists:
• Maintenance work
• Repairs
• Work on electrical equipment
Only authorized persons may work on the machine. Anyone work-
ing on the machine belongs to the operators. Operators must have
read and understand the manual before working on the system.
Setup Control setup and start-up must be performed carefully by qualified
technicians to ensure no health risks for operating personnel.
The connecting cable must have a power plug approved in
the
relevant country. The power plug may only be assembled
to the power cable by qualified specialists.
Operation Check the control while in operation for any externally visible
damage.
Stop working if you notice any changes. Report any changes to
your supervisor.
A damaged control should no longer be used.
Conversions or changes to the control are prohibited.
3.2 Signal words and symbols used in
warnings
Warnings in the text are distinguished by color bars. The color
scheme is based on the severity of the danger. Signal words
indicate the severity of the danger:
To Next Page
Loading...
Need help?
General
