DURKOPP ADLER DAC basic

Table of Contents
Instructions for use DAC basic/classic - DAC eco plus - OP4X00 - 00.0 - 04/2024 1
1 About these instructions .................................................................... 3
1.1 For whom are these instructions intended? ..........................................3
1.2 Representation conventions – symbols and characters........................3
1.3 Other documents...................................................................................5
1.4 Liability ..................................................................................................5
2 Performance description ....................................................................7
2.1 Characteristics.......................................................................................7
2.2 Declaration of conformity.......................................................................7
2.3 Additional equipment.............................................................................8
3 Safety.................................................................................................... 9
3.1 Basic safety instructions........................................................................9
3.2 Signal words and symbols used in warnings....................................... 10
4 Components and functions.............................................................. 13
4.1 Control.................................................................................................13
4.2 Control panel .......................................................................................17
4.3 Setpoint device....................................................................................17
4.4 Proper use...........................................................................................18
5 Control panel ..................................................................................... 19
5.1 OP4X00 control panel .........................................................................19
5.1.1 Navigating the control panel................................................................19
5.1.2 Symbols and tiles ................................................................................20
5.2 Software operating modes ..................................................................21
5.3.1 Adjusting the start bartack...................................................................25
5.3.2 Adjusting the end bartack.................................................................... 26
5.3.3 Adjusting the bobbin stitch counter .....................................................27
5.3.4 Piece counter ......................................................................................28
5.3.5 Maximum sewing speed...................................................................... 29
5.3.6 Adjusting the needle position after sewing stop ..................................30
5.3.7 Point position.......................................................................................30
5.3.8 Screen lock..........................................................................................31
5.4 Automatic mode .................................................................................. 32
5.5 Settings ...............................................................................................36
5.5.1 Operator parameters ...........................................................................37
6 Troubleshooting ................................................................................ 39
6.1 Customer Service................................................................................39
6.2 Error messages ...................................................................................39
7 Technical data ................................................................................... 41
8 Glossary ............................................................................................. 43