About these instructions
Instructions for use DAC basic/classic - DAC eco plus - OP4X00 - 00.0 - 04/20244
Disturbances
Specifies the disturbances that can occur from an incorrect setting.
Cover
Specifies which covers must be removed in order to access the
components to be set.
Steps to be performed when operating the machine (sewing
and equipping)
Steps to be performed for service, maintenance, and
installation
Steps to be performed via the software control panel
The individual steps are numbered:
First step
Second step
The steps must always be followed in the specified order.
Lists are marked by bullet points.
Result of performing an operation
Change to the machine or on the display/control panel.
Important
Special attention must be paid to this point when performing a step.
Information
Additional information, e.g. on alternative operating options.
Order
Specifies the work to be performed before or after a setting.
To Next Page
Loading...
Need help?
General
