Dwyer Instruments UFM2 - Calibration Menu

UFM2/UBT User Manual
Issue 1.1b July 20 Page 25
3.6 Calibration Menu
NOTE: SET ‘ZERO CUT-OFF’ TO ZERO BEFORE SETTING ‘ZERO OFFSET’ THEN GO
BACK TO SET ‘ZERO CUT-OFF’.
NOTE: SCREENS WITHIN THE RED BOX ARE ONLY SHOWN ON UBT MODELS.
Damping Time [s]:
10, 20, 30, 50 or 100
Zero Offset
0.000 ft/s
Range 0.00 – 0.50
0.02 ft/s
Done
71360
Zero Offset:
Averaging…9
^ To Clear
V To Set
Valid & 
Invalid & 


Calibrat. Factor:
1.000
Range 0.500–1.500
1.000
NO |YES
Invalid & 
Valid & 
Zero Temp Offset
NO|YES
No & 
Calibrate #1
H00.0/C00.0: 0.00
Yes & 
Attach Sensors:
Press Enter
Done

Zero Cut-off:
0.02 ft/s

UFM2 Models
UBT Models
Invalid & 
Invalid & 