dynabook TECRA A40-J Series Maintenance Manual

Maintenance Manual (960-945) 4-13
Replacement Procedures
4.13 Memory module
4.13.1 Removing the Memory module
To remove the memory module, follow the steps as detailed below:
1. Open the left and right latches outside and remove the memory
module(s).
Figure 4-9 Removing the memory module(s)
4.13.2 Installing the Memory module
To install a memory module, follow the steps as detailed below:
1. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 30 degree angle before
holding it down until the latches on either side snap into place.
Do not touch the connectors on the memory module or on the computer.
Dust or stains on the connectors may cause memory access problems.
Never press hard or bend the memory module.
1. Latches 2. Memory module
2
1
1

dynabook TECRA A40-J Series Specifications

General

Operating System	Windows 10 Pro
Battery Life	Up to 10 hours
Graphics	Intel Iris Xe Graphics
Bluetooth	Bluetooth 5.1
Processor	Intel Core i5-1135G7 or i7-1165G7
Display	14.0" FHD (1920 x 1080) Anti-Glare
RAM	8GB/16GB DDR4
Storage	256GB/512GB SSD
Wireless	Intel Wi-Fi 6 AX201
Ports	2 x USB 3.2 Type-A, 1 x USB 3.2 Type-C, HDMI, Ethernet, MicroSD card slot
Security	Fingerprint Reader, TPM 2.0
Webcam	HD Webcam