dynabook TECRA A40-J Series - Fin; Figure 4-21 Removing the Fans

Maintenance Manual (960-945) 4-21
Replacement Procedures
Figure 4-21 Removing the Fans
4.18.2 Installing the Fans
To install the Fans, follow the steps below and refer to Figure 4-21.
1. Set the Fans in place on the Cover Assembly and secure them with the
screws.
2. Connect the Fan harness to the connector CN3380 and CN3390 on
the System Board (FMERSY*).
4.19 Fin
4.19.1 Removing the Fin
To remove the Fin, follow the steps below and refer to Figure 4-22.
1. Remove the following screws and then the Fin.
Fan
S2 x 4CT
an
Fan harness
N3390
C
N
Fan Harness
CN3390
N
8
8
CN338
CN3380