dynabook TECRA A40-J Series Maintenance Manual

Maintenance Manual (960-945) 4-17
Replacement Procedures
5. Disconnect the Smart Card FFC from the connector on the Smart Card
slot.
Figure 4-15 Removing the Smart Card slot (3)
4.15.2 Installing the Smart Card slot
To install the Smart Card slot, follow the steps below and refer to Figure 4-
13 to Figure 4-16.
1. Connect the Smart Card FFC to the connector on the Smart Card slot.
2. Set the Smart Card slot in place and secure it the with the screw.
3. Connect the Smart Card FFC to the connector CN2170 on the system
board.
4. Stick the AL TAPE and INSU SC in place.
Figure 4-16 Installing the Smart Card slot
5. Connect the FPC/FFC to the connector CN9600 on the SYSTEM board
and CN9640 on the USB board.
2
1
INSU SC AL TAPE

dynabook TECRA A40-J Series Specifications

General

Operating System	Windows 10 Pro
Battery Life	Up to 10 hours
Graphics	Intel Iris Xe Graphics
Bluetooth	Bluetooth 5.1
Processor	Intel Core i5-1135G7 or i7-1165G7
Display	14.0" FHD (1920 x 1080) Anti-Glare
RAM	8GB/16GB DDR4
Storage	256GB/512GB SSD
Wireless	Intel Wi-Fi 6 AX201
Ports	2 x USB 3.2 Type-A, 1 x USB 3.2 Type-C, HDMI, Ethernet, MicroSD card slot
Security	Fingerprint Reader, TPM 2.0
Webcam	HD Webcam