dynabook TECRA A40-J Series - Ssd; Figure 4-10 Seating the Memory Module

Maintenance Manual (960-945) 4-14
Replacement Procedures
Figure 4-10 Seating the memory module
4.14 SSD
4.14.1 Removing the SSD
To remove the SSD, follow the steps below and refer to Figure 4-11.
1. Remove the the following screw and disconnect the SSD from the
connector CN1900 on the SYSTEM board.
2
1
After installing the memory module, make sure that the memory module is
secured with the left and right latches.
Take care not to press on the top or bottom of a SSD. Pressure may cause
the data loss or damage to the device.