5● Installation DYNACO USA
18 THE SAFEST CHOICE Slimline Series RevB.doc1
5.5 Attachment to the wall
The attachment of the working parts and the doorposts to the wall must be
carried out in accordance with the appropriate methods. The installer must
ensure that the fasteners are suitable for the size of the door and the quality of
the walls; if necessary, increase the number of attachment points.
Measure the floor level.
Place the entire structure around the construction opening.
The inner dimension B, between the door posts, must be 36 mm more than the width of the door
opening stated on the production data sheet that has been supplied with the door.
Please ensure that the parts are level/plumb (drum, sealing beam and doorposts)
Figure 5-3: Fastening to the wall.
For an optimum seal, the openings between the door structure and the walls of
the building must be filled. Please consult the customer with regard to the choice
of materials to be used (foam rubber, silicon, etc.).
To Next Page
Loading...
Need help?
General