3● Safety regulations DYNACO USA
6 THE SAFEST CHOICE Slimline Series RevB.doc1
3.2 About the operating instructions
Please read the operating instructions carefully before using the door.
3.2.1 Precautions during installation
• For the safety of the user and the proper operation of the door, the door must be used in
accordance with the instructions contained in this manual.
• Only authorised personnel may work on DYNACO doors. The personnel concerned must be
properly informed about the contents of the manual, remarks and warnings regarding transport,
and about the installation and commissioning of this door. Work by unauthorised personnel can
bring about risks for the users. Install the door with the assistance of qualified forklift drivers and
electricians.
• Installation by unauthorised personnel will lead to damage to door components and poor
operation of the door.
• Not following the manual during installation, and installation by unauthorised personnel will lead
to an invalidation of the warranty.
• Please ensure that all accessories meet IEC standards.
• The equipment and accessories must be installed in accordance with the manufacturer's
instructions, as well as national and other standards.
3.2.2 Precautions during operation
• Please read the manual before putting a DYNACO door into use.
• Only use the door when the control box is locked.
• Do not touch the safety warnings, covers or safety equipment. Keep these in good order. Safety
warnings must remain visible at all times. Avoid all contact with moving parts during start-up and
maintenance of the door.
• Sometimes, safety equipment needs to be removed for maintenance. Always replace it
afterwards.
3.2.3 Precautions during maintenance
• Only qualified (by DYNACO) personnel is allowed to carry out maintenance on DYNACO doors.
If maintenance is carried out by persons who have not been trained by DYNACO, the warranty
will be invalidated.
• All parts used in DYNACO doors are tailored to their application. Only use original replacement
parts.
• Sometimes, safety equipment needs to be removed for maintenance. Always replace it
afterwards.
3.2.4 Precautions during electrical work
• An electrical discharge can be lethal. Never touch parts that are 'live'. Be very careful during the
installation and maintenance of electrical components of the door.
• Switch off the power supply before carrying out the following work. (Lock the main switch with a
padlock)
To Next Page
Loading...
Need help?
General