7.6 – Menu F: Analog Outputs ................................................................................................................ 31
7.7 – Menu G: Relay Output ................................................................................................................... 32
7.8 – Menu H: Units ................................................................................................................................ 33
7.9 – Menu J: Potentiomtr Setup ............................................................................................................ 34
7.10 – Menu K: Source Select ................................................................................................................. 34
7.11 – Menu L: Process ........................................................................................................................... 36
7.12 – Menu M: Fault .............................................................................................................................. 36
7.13 – Menu N: Auto Restart .................................................................................................................. 39
Section 8 – TROUBLESHOOTING ................................................................................................................ 40
8.1 – Control will not “Run” or “Start” .................................................................................................... 40
8.2 – No Output....................................................................................................................................... 40
8.3 – Drive Runs at Full Speed ................................................................................................................. 40
8.4 – Fuses Blow ...................................................................................................................................... 40
8.5 – Cannot Change any Settings........................................................................................................... 40
8.6 – Follower or Potentiometer Signal Not Changing Setpoint ............................................................. 41
8.7 – Unstable Speed .............................................................................................................................. 41
8.8 – Speed on Display is Different than Actual Speed ........................................................................... 41
8.9 – Screen is Frozen and/or has Unfamiliar Content ........................................................................... 41
8.10 – Screen is Lit, but Nothing is Displayed ......................................................................................... 41
8.11 – Local/Remote Key Does Not Work ............................................................................................... 41
8.12 – Drive Slower than Desired ............................................................................................................ 41
Section 9 – ETHERNET IP AND SERIAL COMMUNICATIONS ...................................................................... 42
9.1 – Data Transceiving Organization ..................................................................................................... 42
9.2 – Read and Write Requests ............................................................................................................... 42
9.3 – Notes .............................................................................................................................................. 42
9.4 – Data Acquisition ............................................................................................................................. 43
Section 10 – INDEX ..................................................................................................................................... 44
To Next Page
Loading...