The SHARK system 11
To operate the indicators
Press the indicator buttons to switch the indicators on or off.
The indicator LEDs flash at the same rate as the indicator lights.
The indicators will switch off automatically, If the
Indicator Auto-cancel parameter does not have the value „Off‟.
To operate the hazard lights
Press the hazard light button to switch the hazard lights on or off.
Both indicator LEDs flash together at the same rate as the
indicator lights.
Operating Attendant Mode
Attendant Mode is selected when the User/Attendant switch on the DK-ACU
Attendant Control module is set to „Attendant‟. In Attendant Mode, the Attendant
Control LED is on.
In Attendant Mode, the joystick of the REMD will not operate. Only the joystick on the DK-ACU is
operational.
See the DK-ACU Installation Manual for further details.
Attendant Control LED is on
To Next Page
Loading...
Need help?
General
