EasyManuals Logo

Dynapac CA150D User Manual

Dynapac CA150D
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
19CA 150 M150EN2
Fig. 24 Left side of engine
1. Drain plug
2. Oil filter
Diesel engine
– Changing the filter and oil
123 1
Make sure there are no naked flames in the
vicinity when checking the electrolyte level.
An explosive gas is formed in the battery
during the charging process.
Lift up the engine compartment cover and undo the
quick-release screws (1).
Raise the battery cover (2).
Dry the upper face of the battery.
Use protective goggles. The battery con-
tains corrosive acid. In the event of con-
tact, rinse with water.
12
EVERY 250 OPERATING HOURS (Monthly)
Position the roller on a level surface. Stop
the engine and apply the parking brake/
reserve brake.
The oil drain plug (1) located in a mount on the rear axle
is most easily accessible from underneath the engine.
Drain the oil while the engine is warm. Place a recepta-
cle for at least 15 litres under the drain plug.
Danger of being scalded when draining off
hot oil. Protect your hands.
Change the engine oil filter (2) at the same opportunity.
See also the engine manual.
WARNING
WARNING
Dispose of the drained oil and filter in an
approved manner.
Battery
– Check electrolyte level
Fig. 25 Battery box
1. Quick-release screws
2. Battery cover
3. Battery
WARNING
WARNING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac CA150D and is the answer not in the manual?

Dynapac CA150D Specifications

General IconGeneral
BrandDynapac
ModelCA150D
CategoryConstruction Equipment
LanguageEnglish

Related product manuals