Dynon SkyView SE - Page 94

Messages and Alerts
9-8 SkyView SE Pilot’s User Guide - Revision I
Spoken Alert
(if configured)
Message Displayed in
Message Window
Visual Alert
(severity)
Description
"Warning"
SKYNET POWER FAULT
A fault has been detected in the
wires that provide power to
SkyView Network devices.
"Slip Trim Nose
Down"
None
Near Top Bar:
The autopilot has carried a large
trim load for an extended period,
and the affected servo is slipping.
"Slip Trim Nose Up"
None
Near Top Bar:
The autopilot has carried a large
trim load for an extended period,
and the affected servo is slipping.
"Warning"
TRIM FEEDBACK STUCK
The trim feedback monitor
received a positive activity signal
during system boot.
"Trim Runaway"
None
On PFD:
SkyView detected electric trim
motor activity that was not
commanded. Requires SV-AP-
TRIMAMP Installation.
"Voltage"
VOLTAGE HIGH
Voltage indicator has entered
configured red high range.
"Voltage"
VOLTAGE LOW
Voltage indicator has entered
configured red Low range.
"Caution"
ACTV ADAHRS
VIBRATION
The currently-active ADAHRS has
detected vibration that will affect
G Meter, autopilot, and attitude
indicator performance.
Troubleshoot when able.
"Caution"
ADAHRS CAL OLD
Calibration of the ADAHRS
module is out-of-date. Contact
Dynon Avionics for assistance.
"Go Around"
None
On PFD:
The autopilot Go Around function
has been engaged.
"Caution"
AP DISCONNECT
BROKEN
The autopilot disconnect switch
wire is broken.
"Caution"
AP DISCONNECT STUCK
The system has detected a wiring
fault in the AP DISC
button/switch.
"Caution"
AP PANEL OFFLINE
The Autopilot Control Panel is no
longer communicating with
SkyView.