Need help?Do you have a question about the EA UltraTEV Plus 2 and is the answer not in the manual?
Defines partial discharges as electrical discharges not bridging insulation, causing progressive insulation deterioration.
Explains detection methods by identifying energy emitted by PD, including electromagnetic, acoustic, and gas.
Introduces the instrument's components, sensors, display, and control buttons for basic operation.
Covers device charging via USB, battery life expectations, and procedures for turning the UTP2 on and off.
Explains the UTP2's menu structure, icons, and how to navigate between different measurement and setting modes.
Details the various measurement modes available, such as TEV, Cable PD, Ultrasonic, and UHF for PD detection.
Guides users on creating measurement workflows, starting, conducting, and completing surveys for asset data.
Outlines methods for connecting the UTP2 and reviewing collected data via Hotspot, Wi-Fi, USB, or MicroSD card.
Instructions for performing Transient Earth Voltage (TEV) measurements, including background noise considerations.
Guide on measuring Partial Discharge in cables using the HFCT accessory and the UTP2 instrument.
How to use the UTP2's ultrasonic sensor and accessories to detect acoustic emissions from partial discharge.
Details on using the UHF Receiver accessory to detect Radio Frequency Interference for PD source identification.
General| Category | Analytical Instruments |
|---|---|
| Sensitivity | 1 pC |
| Accuracy | ± 5% |
| Input Impedance | 1 MΩ |
| Display | LCD |
| Data Logging | Yes |
| PC Interface | USB |
| Power Supply | Rechargeable Battery |
| Battery Life | 8 hours |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C to +60°C |
| Weight | 1.2 kg |
| Technology | Ultrasonic and Transient Earth Voltage (TEV) |
To Next Page