Configuration Using the PROFIBUS Configuration File
24 C441 PROFIBUS Module User Manual MN042002EN—July 2015 www.eaton.com
Motor Control Start Delay Warning Enable S811+ 1 = enable
0 = disable
Motor Control Power on Start Delay S811+ 0.0–600.0 sec (in 0.1 sec)
Motor Control Start Delay S811+ 0.0–600.0 sec (in 0.1 sec)
Motor Control Run Command Change Start Delay S811+ 0.0–600.0 sec (in 0.1 sec)
Motor Ground Fault (Warning) Enable S811+ 0 = Protection disabled
1 = Fault enabled
2 = Warning enabled
Motor Ground Fault Inhibit from Start Delay S811+ 0–200
Table 20. S811+ Soft Starter Configuration File, continued
Parameter Name Location Notes
To Next Page
Loading...
