Eaton i-on Series - Page 125

i-on Range Installer Menu Options
Page 115
Figure
12.
Speech Dialler Programming.
If the control unit has Call Acknowledge enabled (see page 117), then the person receiving
the speech messages can control the link by sending DTMF tones back to the control unit
(usually by pressing buttons on the telephone key pad). The commands available are:
Function
Key
End this call
DTMF ‘5’
Play ‘Home’ and ‘alarm’ message
DTMF ‘3’
Clear down
DTMF ‘9’
Note that when the called party answers a speech dialler call there could be a six second
delay before the control unit starts playing the home message.
Call Mode
This option enables or disables the speech dialler feature. To employ speech dialling set
the call mode to “Enabled”.
Messages
To record the speech messages you wish the speech dialler to use enter Installer Menu
and select Communications – Speech Dialler – Messages.
There are five messages slots available: The Home Message and Messages 1 to 4. The i-
sd01, i-sd02 and i-gsm02 can record up to ten seconds of speech for the Home message,
and up to five seconds of speech for each of the alarm messages. Within each message
you can use any of the following options:
None
Fire Alarm
Hold Up Alarm
Burglar Alarm
Technical Alarm
Mains Fail
Home message
Dest 1 Y
Dest 2 N
Dest 3 Y
Dest 4 N
Message 1
Dest 1 N
Dest 2 N
Dest 3 N
Dest 4 N
Message 2
Dest 1 N
Dest 2 N
Dest 3 N
Dest 4 N
Message 3
Dest 1 N
Dest 2 Y
Dest 3 N
Dest 4 Y
Message 4
Dest 1 = Tel No: 12345678
Dest 2 = Tel No: 87654321
Dest 3 = Tel No: 56781234
Dest 4 = Tel No: 21436587
Report Triggers Messages Destinations Phone Book
Tampers
Soak Test Fail*
*Note:
Not available
on i-on16.