Eaton i-on Series - Page 166

Appendix VII i-on Range
Page 156
Batt= Charger Rstr
Control unit battery charger
working again.
Battery Load OK
Control unit battery passed load
test.
Bell 12V Fail
12V DC supply to bell failed.
Bell 12V Rstr
12V DC supply to bell restored.
Bell Tamper
External wired siren tamper.
Bell Tamper Rstr
External wired siren tamper
restored.
Burg Z== Alarm
Burglar alarm on zone n.
Burg Z== Restore
Burglar alarm on zone n restored.
Bus # Tamper
Bus n has been tampered (for
example wires cut or
disconnected)
Bus # Tamper Rstr
Bus n has been restored.
Codes Defaulted
All access codes were returned to
factory defaults.
Comms 12V Fail
DC power to comms module
failed.
Comms 12V Restore
DC power to comms module
restored.
Configuration Fail
The current configuration is not
compatible with the software
revision level of the control unit.
Defaults Loaded
The control unit was returned to
factory defaults.
Disabled ==
Expander/keypad disabled.
Disabled ==
Expander/Keypad disabled.
Enabled ==
Expander/Keypad enabled.
Enabled ==
Expander/Keypad enabled.
Entry Stray Z==
Stray on entry alarm at zone n.
Exp. == deleted
Expander n deleted from bus.
Expndr == added
Wired expander n added to bus.
Expndr == added
Radio expander n added to bus.
Expndr == found
New wired expander n found on
bus.
Expndr == found
New radio expander n found on
bus.
EXP-PSU A/C Fail Flt
EXP-PSU AC mains fail.
EXP-PSU A/C Fail Rst
EXP-PSU AC mains restored.
EXP-PSU Aux Fuse Flt'
EXP-PSU Aux fuse failed.
EXP-PSU Aux Fuse Rst'
EXP-PSU Aux fuse restored.
EXP-PSU Aux1 O/P Flt'
EXP-PSU auxilliary output 1 fault.
EXP-PSU Aux1 O/P Rst'
EXP-PSU auxilliary output 1 fault
restored.
EXP-PSU Aux2 O/P Flt'
EXP-PSU auxilliary output 2 fault.
EXP-PSU Aux2 O/P Rst'
EXP-PSU auxilliary output 2 fault
restored.
EXP-PSU Batt 1 Rstr'
EXP-PSU battery 1 restored.
EXP-PSU Batt 1 Rstr'
EXP-PSU battery 1 missing
restored.
EXP-PSU Batt 2 Rstr'
EXP-PSU battery 2 restored.
EXP-PSU Batt 2 Rstr'
EXP-PSU battery 2 missing
restored.
EXP-PSU Bus O/P Flt'
EXP-PSU bus dc power output
fault.
EXP-PSU Bus O/P Rst'
EXP-PSU bus dc power output
restored.
EXP-PSU Chargr 1 Flt'
EXP-PSU battery 1 charger fault.
EXP-PSU Chargr 1 Rst'
EXP-PSU battery 1 charger fault
restored.
EXP-PSU Chargr 2 Flt'
EXP-PSU battery 2 charger fault.
EXP-PSU Chargr 2 Rst'
EXP-PSU battery 2 charger fault
restored.
EXP-PSU Coms O/P Flt'
EXP-PSU plug by comms output
fault.
EXP-PSU Coms O/P Rst'
EXP-PSU plug by comms output
fault restored.
EXP-PSU Ex Keys Rstr'
The system was restored after a
user keyed in the wrong code
more than four times in a row at a
keypad.
EXP-PSU Load 1 Fail'
EXP-PSU battery 1 failed load
test.
EXP-PSU Load 1 OK'
EXP-PSU battery 1 passed load
test.
EXP-PSU Load 2 Fail'
EXP-PSU battery 2 failed load
test.
EXP-PSU Load 2 OK'
EXP-PSU battery 2 passed load
test.
EXP-PSU Low Batt 1'
EXP-PSU battery 1 low.
EXP-PSU Low Batt 2'
EXP-PSU battery 2 low.
EXP-PSU Low Voltage'
External PSU reports low voltage.
EXP-PSU Miss Batt 1'
EXP-PSU battery 1 missing.
EXP-PSU Miss Batt 2'
EXP-PSU battery 2 missing.
EXP-PSU Sys Volt Flt'
EXP-PSU system voltage fault.
EXP-PSU Sys Volt Rst'
EXP-PSU system voltage fault
restored.
EXP-PSU Voltage OK'
External PSU reports voltage OK.
Ext A/C Fail Z==
Zone n with type AC Fail activated.
Ext A/C Rstr Z==
Zone n with type AC Fail restored.
Ext Batt Fault Z==
Zone n with type Batt Fault
activated.
Ext Batt Rstr Z==
Zone n with type Batt Fault
restored.
Ext Low Volts Z==
Zone n with type Low Volts
activated.
Ext PSU Fault Z==
Zone n with type Fault activated.
Ext PSU Rstr Z==
Zone n with type Fault restored.
Ext Volts Rstr Z==
Zone n with type Low Volts
restored.
Ext WD Fault Z===
A warning device has reported a
fault through zone n.
Ext WD Restr Z===
The fault reported through zone nn
by a warning device has been
restored.
Fire == Alarm
Fire alarm at keypad.
Fire Reset
User reset system after fire alarm.
Fire Restore
Fire alarm at keypad restored.
Fire Restore
Fire alarm restored from radio
keypad.
Fire Z== Alarm
Fire alarm on zone n.
Fire Z== Restore
Fire alarm on zone n restored.
GSM CME Info --
The GSM plu-on module has a
problem.
GSM CMS Info --
The GSM plu-on module has a
problem.
HU == Alarm
Hold Up Alarm started from
keypad nn.
HUA Cnf RF HD U---
Hold Up Alarm confirmed by radio
HUD belonging to user nn.
HUA Cnf RF MD U---
Hold Up Alarm confirmed by radio
Man Down transmitter belonging
to user nn.
HUA Conf Bus# Tamp
Hold Up Alarm by a bus tamper.
HUA Conf HD ==
Hold Up Alarm confirmed on
keypad HUA keys.
HUA Conf HD RK==
Hold Up Alarm confirmed on radio
keypad HUA keys.
HUA Conf Panel Jam
Hold up alarm confirmed by panel
jamming.
HUA Conf Panel Lid
Hold Up Alarm confirmed by panel
lid tamper.
HUA Conf. ==
Hold Up Alarm confirmed by
tamper on expander n.
HUA Conf. ==ER
Hold Up Alarm has been
confirmed by a missing external
prox reader on keypad n.
HUA Confirm
Hold Up Alarm confirmed on
device...