Eaton i-on Series - Page 167

i-on Range AppendixVII
Page 157
HUA Confirm ==
Hold Up Alarm confirmed on
keypad HUA keys.
HUA Confirm Aux #
Hold Up Alarm confirmed by open
circuit on AUX Tamp terminals on
control unit PCB.
HUA Confirm Bell #
Hold Up Alarm confirmed by open
circuit on TR terminal on control
unit PCB.
HUA Confirm RK==
Hold Up Alarm confirmed by
tamper on radio keypad.
HUA Confirm SRN==
Hold Up Alarm confirmed by radio
siren n tamper.
HUA Confirm WAM==
Hold Up Alarm confirmed by
tamper on WAM n.
HUA Confirm Websvr
A Hold Up Alarm was confirmed
by a user on the web browser
interface typing the password
incorrectly more than four times in
a row,
HUA Confirm Z===
Hold Up Alarm confirmed on wired
zone nn.
HUA Restore
Hold Up Alarm button has been
restored.
HUA Restore
Hold Up Alarm has been restored.
HUA Restore
Hold Up Alarm has been restored.
HUA Z== Alarm
Hold Up Alarm on zone n.
HUA Z== Restore
Hold Up Alarm on zone restored.
HUD Fault Rst Z===
A hold up device fault reported on
zone n was restored.
HUD Fault Z===
A hold up device reported a fault
on zone n.
IP Polling Fault
The Chiron Ethernet or Chiron
GPRS plug on module is having a
problem.
IP Polling Restore
The problem with the Chiron
Ethernet or Chiron GPRS module
has been restored.
Jamming ==
Jamming detected.
Jamming == Rstr
Jamming ceased.
K== Excess Keys
Excess keys tamper at keypad n.
Key Sw Ptn # PtSet
Partition part set from keyswitch.
Key Sw Ptn # Set
Partition set from keyswitch.
Key Sw Ptn # Unset
Partition unser from keyswitch.
Key Sw System PtSet
System part set from keyswitch.
Key Sw System Set
System set from keyswitch.
Key Sw System Unset
System unser from keyswitch.
Keypad == added
New keypad added to system.
Keypad == found
New keypad found on bus.
Keypad 12V Fail
Bus DC power failed at keypad.
Keypad 12V Restore
Bus DC power restored at keypad.
Kpd == deleted
Keypad deleted from system.
Lid Tamper Restore
Control unit lid closed.
Lockset Z=== Set
A zone with type "lock set" was
closed. (If Inverted attribute is set
to "normal".)
Lockset Z=== Unset
A zone with type "lock set" was
opened. (If Inverted attribute is set
to "normal".)
Low Batt Restore
Control unit battery no longer low.
Low Batt Z== Rstr
Radio detector at zone has low
battery restored.
Low Battery
Control unit battery low.
Low Battery Z==
Radio detector at zone has low
battery.
Mains Fail
Mains fail at control unit.
Mains Restore
Mains restored at control unit.
Mask Flt Z==
Masking detected on zone while
partition unset?
Mask Restore Z==
Masking restored on zone.
Mask Z==
Masking detected on zone while
partition set.
Missing ==
Expander missing from bus.
Missing == Rstr
Missing expander restored to bus.
Missing ==ER
An External prox Reader
connected to keypad nn has gone
missing (possibly disconnected
from the keypad).
Missing ==ER Rs
An External prox Reader
connected to keypad nn has been
re-connected.
Occupancy Set W#
A user set a ward while an
occupancy zone was active.
Override
User overrode set fail in part
setting system.
PA U-- Low Bat
Hold up Device belonging to user
has a low battery.
Panel lid open
Control unit lid open.
Panic == Alarm
Panic alarm at keypad.
Panic Alarm Rstr
Hold Up Alarm restored.
Panic Alarm Rstr
Hold Up Alarm from radio keypad
restored.
Panic Alrm Rst P#
Panic alarm at keypad in partition
restored.
Panic Alrm Rst P#
Hold Up Alarm in partition
restored.
Panic Alrm Rst P#
Hold Up Alarm from radio keypad
in partition n reset.
Panic U-- Alarm
User started a panic alarm from a
Hold Up Device.
Partn # Rearmed
Partition n was rearmed after an
alarm by control unit.
Pend U-- Low Bat
Pendant belonging to user has a
low battery.
Pri Comms Path Flt
Primary communications path has
a fault.
Pri Comms Path Rst
Primary communications path fault
restored.
Ptn # Remote Rst
User reset partition remotely.
Remote Reset
User reset system remotely.
Remote U-- Low Bat
Remote control belonging to user
has low battery.
Remsvc Comms Fail
A remote service call failed all
attempts.
Remsvc Complete
A remote service call succeeded.
RF Failure
Radio failed.
RF Failure Restore
Radio restored.
RF Jamming
Radio jamming detected.
RF Jamming Restore
Radio jamming removed.
RK == Panic Alarm
Hold Up Alarm raised at radio
keypad n.
RK== Ex Keys Rstr
The system was restored after a
user keyed in the wrong code
more than four times in a row at
radio keypad n.
RK== Excess Keys
Radio keypad n has been
tampered by excess keypresses.
RK== Fire
Fire alarm raised at radio keypad
n.
RK== Low Battery
Radio keypad n has low battery.
RK== RF OK
Radio keypad n supervision OK.
RK== RF Warning
Radio keypad n about to fail
supervision.
RK== Superv Fail
Radio keypad n failed supervision.
RK== Superv Rstr
Radion keypad n supervision
restored.
RK== Tamper
Tamper on radio keypad n.
RK== Tamper Rstr
Tamper on radio keypad n
restored.
Sec Comms Path Flt
Secondary communications path
has a fault.