Eaton i-on Series - Page 51

i-on Range The Installer Menu
Page 41
MENU Option
Factory Default
Notes
Technical Alarm: No
Masking: Yes
Tampers: Yes
Set/Unset: Yes (see Note 2)
Part Set: Yes(see Note 2)
Reset: Yes (see Note 2)
Exit timeout: Yes
Omit: Yes
RF Supervision: Yes
RF Jamming: Yes (see Note 2)
RF Battery/PSU: Yes (see Note 2)
Panel Battery: Yes (see Note 2)
Mains Fail: Yes (see Note 2)
Faults: Yes (see Note 2)
Installer Mode: Yes (see Note 2)
User Code Changed: Yes
Time/Date Reset: No
Downloading: No
2. This setting is required in order
to comply with EN50131.
Downloading and masking events
not available on i-on16.
Restorals
Enabled
Burg Comms Rearm
Enabled
Appears only when Report
Type=Fast Format AND when
Confirmation Mode = “Basic”
21CN FF Ack time
800ms
Appears only when Report
Type=Fast Format.
Send tamper as burg
Disabled
Appears when Report Type=CID
or SIA.
Dynamic Test Call
Enabled
Appears only when StaticTest Call
disabled
Static Test Call
Disabled
Appears only when Dynamic Test
Call disabled.
To comply with EN50131, either
Static or Dynamic test calls must
be enabled. This is available only
when an i-sd02 is fitted and ARC
Communications enabled.
Unset Comms
Enabled
Speech Dialler
Only visible when suitable
communications module fitted.
Call Mode
Disabled
Messages
None
Phone Book
Empty
Triggers
None
Destinations
None
Call Acknowledge
Enabled
SMS
Only visible on i-on30EXD and i-
on50EXD or when suitable
communications module fitted..
Call Mode
Disabled
Messages
Blank
Phone Book
Empty
Triggers
None
PSTN SMS
Protocol
ETSI Protocol 1 (i-on40 and i-onEX range)
TAP-8N1 (i-on16 only)
Service Centre Tel
1470,17094009 (i-on40 and i-onEX range)
07785499993 (i-on16 only)
BT
Own Telephone No.
Empty
Appears only protocol=UCP
Line Fail Response
Audible
Only visible on i-on30EXD, i-
on50EXD or when suitable
communications module fitted..
Line Fail Delay
9s
This setting is required in order to
comply with EN50131.