User Menu Options
Page 47
Add Event
Use System Config – Calendar Set – Add Event to create an event. When
you select the option, the control unit will guide you through the following
series of options:
Event Name Enter up to 12 characters or press to leave the
default name. See page 27 for details of how to edit
text.
Event Time Specify the time you want the event to occur, then to
display the next prompt.
The time “00:00” is midnight, at the beginning of a new
day.
Note that if you specify a start time that is less than 10
minutes from the current time shown by the control unit
clock (that is, less than the period set by Warning Time),
the event will not take action until the following day.
Event Days Choose the days you want the event to occur.
Press or to scroll through each day of the week.
Press or to specify Yes or No.
Event Actions In a partitioned system, press or to scroll through
each partition, and or to select No (no action), Full
(full set), Part (part set) or Unset.
In a part-setting system, select one of: Full Set, Part Set
B (or C or D) or Unset.
Event Exceptions Choose the exceptions (set up using Add Exception)
that you want to apply to the event.
Press or to scroll through the list of programmed
exceptions. Press or to specify Yes (the exception
applies to the event) or No.
Warning Time Specify the period (in minutes) you want the control unit
to sound the warning tone before the start of a setting
event. Enter between 1 and 30 minutes. The default is
10. There is no specific warning indication for an unset
event.
The warning tone sounds at the keypads and
loudspeakers allocated to the partition(s) specified in
the event.
To Next Page
Loading...
Need help?
General
