Eaton Power Xpert 9395P - Figure 79. UPS Controls and Indicators - Continuous Static Switch

Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201764—Rev 14 133
CChhaapptteerr 77 UUPPSS OOppeerraattiinngg IInnssttrruuccttiioonnss
This section describes how to operate the UPS using either the older LCD non-touch panel or the newer color
touchscreen control.
Refer to Section 7.2 Using the LCD Control Panel or Section 7.6 Using the Color Touchscreen Control Panel for
the appropriate item. This section describes how to operate the UPS.
NOTE Before starting the UPS, ensure all installation tasks are complete and a preliminary
startup has been performed by authorized service personnel. The preliminary startup
verifies all electrical interconnections to ensure the installation was successful and the
system operates properly.
NOTE Read this section of the manual and have thorough knowledge of UPS operation before
attempting to operate any of the controls.
NOTE The UPS displays 2 minutes of battery runtime at the initial startup. After a 24-hour
charging period, the UPS automatically runs a battery test and the correct battery
runtime displays.
77..11 UUPPSS CCoonnttrroollss aanndd IInnddiiccaattoorrss
The controls and indicators identified and described in this section are used to control and monitor UPS
operation. Figure 79 shows the controls and indicators.
Figure 79. UPS Controls and Indicators – Continuous Static Switch
Pushbutton
Control Panel
AC Input Breaker
CB1 (optional)
ISBM