134 Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201764—Rev 14
77..11..11 CCoonnttrrooll PPaanneell
The control panel is used to set up and control the UPS, and to monitor UPS operation. For a description of the
UPS control panel functions, see paragraph 7.2 Using the LCD Control Panel.
77..11..22 CCiirrccuuiitt BBrreeaakkeerrss
Optional circuit breaker (CB1) is used to control the AC input to the UPS rectifier. CB1 is not available with the
separate UPM rectifier feed configuration.
77..22 UUssiinngg tthhee LLCCDD CCoonnttrrooll PPaanneell
The following paragraphs describe the UPS control panel, including controls and indicators, and how to monitor
UPS operation. The control panel (see Figure 80) is located on the front door of the UPS.
Figure 80. UPS Control Panel
3
1
2
PRESS ANY KEY TO CONTINUE
The control panel consists of:
• A liquid crystal display (LCD) (1)
• A horizontal row of pushbutton switches (2)
• A vertical column of status indicators (3). See paragraph 7.2.1 Status Indicators .
The following paragraphs describe using the UPS control panel to monitor the UPS. See paragraph
7.3 Single UPS Operation for use of the operational controls. When the unit powers up, the screen displays the
Eaton logo as shown in Figure 80. To advance to the Main Menu and Mimic screen, press any control panel
pushbutton once.
When the unit powers up, the screen displays the Eaton logo as shown in Figure 80. To advance to the Main
Menu and Mimic screen, press any control panel pushbutton once.
77..22..11 SSttaattuuss IInnddiiccaattoorrss
The four symbols on the right side of the control panel are status indicators. These colored light emitting diode
(LED) lamps work with the alarm horn to let you know the operating status of the UPS.
Table 29 describes the status indicators.
UPS Operating Instructions
To Next Page
Loading...
