92 Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201764—Rev 14
Figure 48. Powerware Hot Sync CAN Bridge Card.
NOTE Only one Powerware Hot Sync CAN Bridge Card can be installed in the UPS. Multiple
CAN cards are not supported and will cause system conflicts.
To install the card:
1. Verify the UPS system is turned off and all power sources are removed. See
Chapter 7 UPS Operating Instructions for shutdown instructions.
2. Unfasten the front door latch and swing the door open (see Figure 16).
3. Install the Powerware Hot Sync CAN Bridge Card into an open X-Slot communication bay on the front of
the UPS. See Figure 27 and Figure 33 for X-Slot communication bay locations.
To locate the appropriate terminals on the Powerware Hot Sync CAN Bridge Card, see Figure 49 and
Table 23.
Installing Options and Accessories
To Next Page
Loading...
