Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201764—Rev 14 191
Figure 107. System Events Screen
77..66..1122 UUsseerr LLoogg
Select LOGS from the menu bar on the main menu screen to look at the active events screen. This screen
shows any currently active alarms, notices, or commands.
• System Event Horns – The system event horn beeps to alert an operator that an event needing attention
is taking place. The horn cycles at a half-second rate.
• System Event Indicators – The status indicators on the UPS control panel work with the event horn to let
the operator know when the UPS is operating in any mode other than normal. Only the ON indicator is
visible during normal UPS system operation. The other indicators illuminate to indicate alarms or events.
When an alarm occurs, first check these indicators to see what type of event has taken place. For
descriptions of the status indicators, see paragraph 7.6.1 Status Indicators.
• System Event Messages – When a system event occurs, a message appears on the LCD in the UPS
status area. This message is also written to the Active Events Log and may be added to the History Log.
The messages are divided into four categories: alarms, notices, status, and commands. The user log
window (1) allows the operator to enter any number up to the number shown to the right of the box. Each
window shows five events. The operator can also use the UP/DOWN arrows above and below the blue
field (2) showing the number of events in the log. See Figure 108.
UPS Operating Instructions
To Next Page
Loading...
