Eaton Power Xpert 9395P - Page 162

Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201764—Rev 14 141
Table 31. Display Menu Operation (Continued)
Function Sub-function Operation
pushbutton to make the change. When finished making changes, use the left or right
arrow pushbutton to highlight SAVE and the up or down arrow pushbutton to select YES.
To complete the save function and return to the System Setup screen, select the return
arrow pushbutton.
Set Date and Time
DD/MM/YYYY
The Set Date and Time DD/MM/YYYY screen allows the internal date and time of the UPS
to be set in the day/month/year format. The date and time information is used for display
on the screen and for logging events in the Event and History Logs. Use the left or right
arrow pushbutton to highlight the setting to be changed. Use the up or down arrow
pushbutton to make the change. When finished making changes, use the left or right
arrow pushbutton to highlight SAVE and the up or down arrow pushbutton to select YES.
To complete the save function and return to the System Setup screen, select the return
arrow pushbutton.
Com Port Selection The Com Port Setup screen allows selection of the serial COM port to set up. Select COM
PORT SETUP from the System Setup Level 1 menu to display the COM Port Setup screen.
Use the up or down arrow pushbutton to highlight the COM port to be set up, then press
the SELECT pushbutton. To return to the System Setup screen, press the ESC pushbutton.
Com Port Setup The COM Setup screen is used to change and save the settings for the selected serial
communication port. The COM port number selected from the COM Port Setup screen
displays. If the changes are not wanted, use the ABORT pushbutton to return to the COM
Port Setup screen. Use the up or down arrow pushbutton to highlight the setting to be
changed. Use the return arrow pushbutton to toggle through the values for the setting to
make the change. Press SAVE or ABORT. Once the action is completed, the COM Port
Setup screen is displayed.
Controls See paragraph 7.2.8 System Status Screen and Controls for details.
77..22..77 LLooaadd OOffff SSccrreeeenn
The Load Off screen (Figure 83) is displayed when the LOAD OFF pushbutton is selected from the main menu
bar, the UPS Control Command screen, or the Bypass Control Command screen. This screen allows the LOAD
OFF process to be aborted if the LOAD OFF pushbutton was pressed accidentally. For Load Off procedures,
see paragraph 7.3.24 Using the UPS LOAD OFF Pushbutton or Command or paragraph
7.4.27 Using the UPS LOAD OFF Pushbutton or Command.
UPS Operating Instructions