Eaton PowerXL DG1 - FR6 Wiring; CHAPTER 6-INSTALLATION REQUIREMENTS, Continued; Figure 21. FR6 Wiring Layout

37
Chapter 6—Installation requirements
POWERXL SERIES VFD MN040002EN—February 2018 www.eaton.com
FR6 wiring
Figure 21. FR6 wiring layout
FR6 wiring process
Step 1: Strip power wire jacket (Stripping length according
toTable 30).
Step 2: Connect the power wire to a lug. Use a tool to press
the wire and lug together tightly.
Step 3: Connect the power wire to the FR6 terminal block,
lock the wire by a nut. Depending on the current
level, one or two power wires can be connected to
each pole of the terminal block.
Connection with
two power wires