EasyManuals Logo

Eaton S801+ Series User Manual

Eaton S801+ Series
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Receipt/Unpacking
S801+ Soft Starter MN03900002E—November 2012 www.eaton.com 5
Receipt/Unpacking
General
Upon receipt of the unit, verify that the catalog number and
unit options stated on the shipping container match those
stated on the order/purchase form.
Inspect the equipment upon delivery. Report any crate or
carton damage to the carrier prior to accepting the delivery.
Have this information noted on the freight bill. Eaton is not
responsible for damage incurred in shipping.
Unpacking
Carefully remove the unit from the shipping container. Check
the unit for any signs of shipping damage. If damage is found
after unpacking, report it to the freight company. Retain the
packaging materials for carrier to review.
Verify that the unit’s catalog number and options match
those stated on the order/purchase form.
CAUTION
Unit may weigh up to 103 pounds. Use suitable lifting device.
Storage
It is recommended that the unit be stored in its original
shipping box/crate until it is to be installed.
The unit should be stored in a location where:
The ambient temperature is –58° to 158°F (–50° to 70°C)
The relative humidity is 0–95%, non-condensing
The environment is dry, clean and non-corrosive
The unit will not be subjected to shock in excess of 15gs
and/or vibration exceeding 3g in any direction.
Shipping
S801+Soft Starters are to be shipped in packaging that
adequately protects the unit.
S801+ units installed in an OEM system as a mounted
assembly in a cabinet or panel in enclosed control systems
are to be adequately secured and shipped via Air-Ride carrier
to prevent damage from excessive shock or vibration during
shipment.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eaton S801+ Series and is the answer not in the manual?

Eaton S801+ Series Specifications

General IconGeneral
Product SeriesS801+
CategoryController
Input Voltage24 VDC
Output Voltage24 VDC
Number of Inputs8
Protection ClassIP20
Communication ProtocolModbus

Related product manuals