Eaton S801+ Series - S801+ Operating Configuration; User Interface

S801+ Operating Configuration
S801+ Soft Starter MN03900002E—November 2012 www.eaton.com 25
S801+ Operating Configuration
Introduction
The S801+ has a wide range of operation and protection parameters to enable coordinated
motor and load protection. Several protections options and Ramp Start/Current Limit start
profiles may be selected on the Control Interface Module (CIM).
The unit is supplied with default settings that accommodate general induction motor
applications that provide very basic motor protection. The user should adjust the parameters
to their specific application.
User Interface
A Control Interface Module (CIM) is used to configure all
models of the S801+ Soft Starter.
Control Interface Module (CIM)
Control Interface Module (CIM)
The S. S. trip LED indicates the operating status of the
S801+.
●
S. S. Trip
●
General fault (Fault codes)
●
Overload
●
Hardware failure
●
Protections
●
Overload
●
Jam
●
Stall
●
Phase loss
●
Phase reversal
●
Fault Reset Method
●
Ramp Start/Current Limit Selection
●
Ramp Start or Current Limit Start Ramp Time and Initial
Torque Potentiometers
●
Kick Start Ramp Time and Kick Start Torque
Potentiometers
●
Soft Stop Ramp Time Potentiometer
●
Overload Class DIP Switches
●
Motor Full Load Amps (FLA) Setting
FLA Potentiometer Setting Values
S. S. Trip
Protections Enable
Reset Mode
Start Profile
Overload Trip Class
Full Load Amps (FLA)
Stop Ramp Time
Start Torque and Time
Kick Start Torque and Time
Catalog
Number
Potentiometer Setting
I
FLA
ABCD
S801N37… 11 19 27 37
S801N66… 20 35 50 66
S801R10… 32 56 80 105
S801R13… 42 73 104 135
S801T18… 56 97 138 180
S801T24… 75 130 185 240
S801T30… 95 164 233 304
S801U36… 112 194 276 360
S801U42… 131 227 323 420
S801U50… 156 270 384 500
S801V36… 112 194 276 360
S801V42… 131 227 323 420
S801V50… 156 270 384 500
S801V65… 203 352 501 650
S801V72… 225 390 555 720
S801V85… 265 460 655 850
S801V10… 320 547 773 1000