Eaton SPD Series Installation Manual

36 Eaton SPD Series for Mounting External to Electrical Distribution Equipment Installation Manual IM01005031E—Rev 09
FFiigguurree 5511.. MMooddiiffyyiinngg TTiimmeeoouuttss
In the network window the following options are listed.
FFiigguurree 5522.. NNeettwwoorrkk TTaabb OOppttiioonnss
The user can select the IP allocation method between three options and the IP address is also displayed here.
The IP allocation method change does not take effect until the unit has been rebooted. The reboot command is
available under General tab, Device Actions. (Do not select the Factory Reset command or the device will
return to the factory default value with a static IP address.)
IP Allocation Methods available:
• Statically Hardcoded (192.168.1.254) Factory default
• DHCP Allocated (Network assigned)
• Taken from NV (stored IP address)
NNOOTTEE The user must reboot the device after performing any of these changes.
Power Xpert SPD User Setup

Eaton SPD Series Specifications

General

Type	Surge Protective Device
Voltage Rating	120/240V, 208Y/120V, 480Y/277V
Surge Current Capacity	Up to 200kA
Modes of Protection	L-N, L-G, N-G
Operating Frequency	50/60Hz
Certifications	UL 1449
SPD Type	Type 1, Type 2
Maximum Surge Current	Up to 200kA
Nominal Discharge Current (In)	10kA, 20kA
Short Circuit Current Rating (SCCR)	Up to 200kA
Enclosure Type	NEMA 1
Mounting	Panel Mount
Standards	UL 1449, IEEE C62.41
Diagnostics	Visual Indicators
Remote Monitoring	Optional
Maximum Discharge Current (Imax)	Up to 200kA