5-O&M_Diagnostics_r1e Section 3Page 5
EBTRON, Inc • 1663 Hwy 701 S., Loris, SC 29569 • Toll Free: 800-2EBTRON (232-8766) • Fax: 843-756-1828 • EBTRON.com
5.2. DEV INFO (DEVICE INFORMATION)
The DEV DIAG submenu contains the following information:
• DEV SN (Device Serial Number)
• PCB SN (Main PCB Serial Number)
• CON SN (Connector Card Serial Number)
• PCB FW (Main Circuit Board Firmware Version)
• CON FW (Connector Card Firmware Version)
• OUT FW (Output/Network Card Firmware Version)
• BLE FW (Bluetooth Low Energy Radio Firmware Version)
• Pb (On-board Barometric Pressure Sensor Reading)
5.2.1. Device Serial Number [DEV SN]
The serial number of the transmitter system.
[Menu path: SETTINGS ↓ DIAGNOSTICS > DEV INFO > DEV SN]
Applies to: All transmitter models.
The device serial number is identified by a label located on the transmitter enclosure.
5.2.2. Main PCB Serial Number [PCB SN]
The serial number of the main circuit board.
[Menu path: SETTINGS ↓ DIAGNOSTICS > DEV INFO >↓ PCB SN]
Applies to: All transmitter models.
5.2.3. Connector Card Serial Number [CON SN]
The serial number of the 8-connector receptacle card.
[Menu path: SETTINGS ↓ DIAGNOSTICS > DEV INFO >↓ CON SN]
Applies to: GTx108-F/An models only.
5.2.4. Main PCB Firmware Version [PCB FW]
The firmware version of the main transmitter circuit board (i.e. the transmitter operating system)
[Menu path: SETTINGS ↓ DIAGNOSTICS > DEV INFO >↓ PCB FW]
Applies to: All transmitter models.
5.2.5. Connector Card Firmware Version [CON FW]
The firmware version of the 8-connector receptacle card.
[Menu path: SETTINGS ↓ DIAGNOSTICS > DEV INFO >↓ CON FW]
Applies to: GTx108-F/An models only.