SD Series Dry Cabinets Setup and Operation Manual | A62-3337-00 Rev: 1.0.0 Page 94
11.6 SYSTEM RESET
If the Main display becomes unresponsive or is operating erratically, you can perform a system reset by doing
a power cycle or pressing a system reset button.
USE EXTREME CAUTION PERFORMING THESE STEPS AS TOUCHING AREAS OTHER THAN SPECIFED
could result in personal injury or damage to property other than the equipment.
Power Cycle:
1) Unplug the power cord.
2) Plug back in and let the cabinet start up.
System Reset Button:
1) Six hardware screws from the back side of the Cabinet Cover.
To Next Page
Loading...
Need help?
General
