ECD SmartDRY SD Series User Manual

SD Series Dry Cabinets Setup and Operation Manual | A62-3337-00 Rev: 1.0.0 Page 8
5.0 SETUP AND INSTALLATION
The installation of the ECD SmartDRY™ Cabinet may be performed by the end user. Local, city, county, or
other jurisdictions may govern the use of this equipment. If you have any questions about local requirements,
please contact the appropriate local agency.
The ECD SmartDRY™ Cabinet is intended for indoor use only, at room temperatures between 15°C and 35°C, at
no greater than 80% relative humidity (at 25°C) and <2, 000 meters (6,561ft) elevation.
5.1 POWER SOURCE
The power requirements are listed on the cabinet serial number label. The supply voltage should not vary
more than 10%.
Position the unit to allow user access to the power cord for mains disconnect.
PLUG THE UNIT INTO A PROPERLY GROUNDED AND RATED RECEPTACLE OF THE CORRECT TYPE.
THE VOLTAGE AT THE RECEPTACLE SHOULD NOT VARY MORE THAN 10% FROM THE LISTED RAT-
ING.

ECD SmartDRY SD Series Specifications

General

Brand	ECD
Model	SmartDRY SD Series
Category	Dryer
Language	English