ECD SmartDRY SD Series

To Next Page

To Previous Page

SD Series Dry Cabinets Setup and Operation Manual | A62-3337-00 Rev: 1.0.0 Page 54

4) Select the RH Setpoint field to make active. Use the Up or Down buttons to adjust the desired value.

5) Select the ON/OFF toggle and OK button to make active.

Main Page

Table of Contents4
Introduction7
Receiving and Inspection9
Inspection9
Loss or Damage9
Shipping Materials9
Return Shipment9
Accessories9
Graphic Symbols10
Operators Safety Information13
Setup and Installation14
Power Source14
Location15
Lifting and Handling16
Leveling16
Filiment Reel Rack Placement17
Light Tower (Optional)19
Control Panel21
Main Display21
Current RH22
Current Temperature22
Status Indicators23
Count down Timer25
Graph Display25
Menu System26
Down Arrow27
Up Arrow27
Interior Lighting28
Alarm Mute28
Alarm Cancel29
Network Dashboard30
Dashboard30
Settings32
Setup33
Viewing Initial ECD Smartdry™ Data33
Quick Start34
Safety and Installation36
Location36
Filiment Reel Rack Configuration36
Power36
Time Settings37
Clear History40
Operation42
ECD Smartdry™ Menu System44
RH Setpoint45
Alarms (Smartdry™ Mode)47
Smartbake™ Menu (Model 3D-10SB Only)51
Smart Settings52
Manual Bake54
Alarms (Smartbake™ Mode)56
Other Settings61
Units61
Date/Time63
Data Logging65
Network67
Sensor69
Lighting71
Passcode73
Help75
Graph76
Equipment Maintenance77
Cleaning77
ECD Smartdry™ Humidity and Temperature Sensor78
Clock Battery79
ECD Smartdry™ Dryer80
Power Board82
Rh/Temperature Probe86
Smartbake™ Heater87
Door Switch89
Light Tower Replacement90
Service and Troubleshooting96
Main Display Is Black96
RH Set Point Is Not Achieved97
Bake Temperature Set Point Is Not Achieved97
System Alerts98
Updating ECD Smartdry™ Cabinet Firmware and Network Dashboard99
System Reset100
Contact Information102
Appendix103
Appendix A: Parts List103
Appendix B: Specifications104
Appendix C: Schematic106
Appendix D: Gossary108
Appendix E: Network116

ECD SmartDRY SD Series - Page 60

Table of Contents

Related product manuals