To Next Page

To Previous Page

SD Series Dry Cabinets Setup and Operation Manual | A62-3337-00 Rev: 1.0.0 Page 2

Although pre-programmed, the Cabinet must run for a minimum of 8 hours to acclimate and regenerate its

dryer module. Please allow this time before adding your filiment. Also, the alarm limits have been pre-pro-

grammed however, are not enabled. Once the Cabinet has stabilized at set point, the alarms can be enabled if

desired. You may also want to explore the other Alarms: SmartDRY™ Temperature, SmartBAKE™ RH, and

SmartBAKE™ Temperature, enabling them as you wish. Refer to section 9.1.2 Alarms (SmartDRY™) in the

Setup and Operation Manual for detailed information.

When accessing options that require a Passcode the system default Passcode is 314. As you enter

protected options, you will be prompted to enter it using the Up or Down buttons. Once se-

lected, all locked options remain “unlocked” until you return to the Main Display.

1) When prompted, Press and hold the Up or Down button to navigate to Passcode 314.

Press the OK button to be able to edit the protected field.

Questions and Answers:

Need help?

Do you have a question about the ECD SmartDRY SD Series and is the answer not in the manual?

ECD SmartDRY SD Series Specifications

General