Ecom ECP2010 - Page 8

ECP2010 / ECP2010H
8 / 68
P/N
Qty.
Picture
Description
00051478
1
Terminal block 8 pins green
(for IO INTERFACE connector)
18329000
1
Screwdriver Torx TX06
(for replacement of seals in washing head)
18331000
1
Screwdriver Torx TX20
(for mounting injector holder, mounting heads during seals replacement)
E1132890
1
Open End Wrench 1/4-5/16"
(for metal through bolts on capillaries, for mounting valve holders)
ACA99400
1
Capillary injector-column 0.25 mm with fittings
(OD=1/16“ ; l=300mm ; volume =15µL ; thread 10-32 UNF)
ACA99300
1
Outlet capillary to injector 0.25 mm with fittings
(OD=1/16“ ; l=300mm ; volume =15µL ; thread 10-32 UNF)
ABA16000
1
Tubing 1/8" 900 mm with filter 2 um and lid
(ID=1/16“ ; volume=1781µL only tubing ; thread ¼“-28 UNF ; lid for
mobile phase reservoir LCT 02 with plug for tubing ; metal filter ; guide
for connection attached)
ACA99500
1
Waste tubing bypass
(from by-pass valve to waste system)
YY005000
1
Syringe LUER 10 ml, plastic
ACA99012
1
Injector holder Series 2000
(combined holder for injecting valves of Rheodyne and Vici type)
ACA99700
1
Back washing set for ECP2010
ACA99000
1
Waste set ECP2010
ACA99020
1
Tool for 1/8" removal
(for replacing seals in heads)
00016000
1
Door 2000
(To be installed after complete installation of the unit! Never manipulate
with the unit, if the door is mounted!)
DOC00004
1
Flash disk with User Manual
DOC00002
1
-
Production protocol
Spare parts and selectable accessories see 12. Spare Parts.