Front Matter HiVol 3000 User manual 1.7
ii
WARNING
Hazardous voltages exist behind the sampler control panel and within the sampler
housing. Ensure the control panel and front and rear enclosure panels are always in
place when the sampler is connected to the mains. The front doors should be closed
when the sampler is left unattended. Ensure the power cord, plugs and sockets are
maintained in a safe working condition.
Ecotech recommends the use of Earth-Leakage Protection Circuit Breakers (ELCB)
on the power supply to the HiVol. If operating from a generator, power conditioner,
isolation transformer, or other floating supply, refer to the section on Instrument
setup, as some important modifications are required.
Safety requirements
• To reduce the risk of personal injury caused by electrical shock, follow all
safety notices and warnings in this documentation.
• If the equipment is used for purposes not specified by Ecotech, the protection
provided by this equipment may be impaired.
• Replacement of any part should only be carried out by qualified personnel,
only using parts specified by Ecotech. Always disconnect power source before
removing or replacing any components.
To Next Page
Loading...
Need help?
General
