Installation HiVol 3000 User manual 1.7
28
2.5 Transporting/Storage
The weight of the HiVol exceeds the Occupational Health and Safety
limits for lifting by one person. Lifting should be done by two people
(one on either side) using the handles supplied.
Carefully transport the sampler to the monitoring site. The sampler should
be transported in an up-right position at all times, and the original packing
should be used to prevent damage. The HiVol and inlet hood should be
transported separately. Whenever the inlet hood is removed for
transportation, re-fit the pivot bolts to the sampler to prevent them being
misplaced. Remove the optional wind sensor and bracket if fitted.
On arrival at the monitoring site, the equipment should again be inspected
for damage. Ensure the inlet hood (especially SSI type) is free from dents
or deformation which may affect collection efficiency. Fit the inlet hood
to the sampler as described in Section 2.2.1.
To Next Page
Loading...
