• Rain rate
5.2 Setting Mode
Settings mode can be activated from “normal mode” by pressing the MENU
once. Doing so will show a screen titled “Setup” that offers 10 individual
buttons for changing configuration of specific settings.
Use the GRAPH or TEMP button to move to the next, or previous, setting
(indicated by a right arrow above the button). The selected setting will be
highlighted in yellow. Press the RAIN button to change the settings for the
selected item. For some items you will now be able to change its value, for
others (when labeled “Setup” you will enter a sub-menu that again allows you
to select a specific item first. Use the RAIN/+ and TEMP/- buttons to change
the value selected in small changes or hold these buttons for two seconds or
more to make rapidly repeating large changes. In the following buttons will
sometimes be referred to as just “next”, “previous”, “+” or “-” if that is their
function.
Press MENU again to return to the previous menu or normal mode.
5.2.1 Backlight
In backlight setting mode you use the GRAPH/next button to move between
the items you can change:
• Enable or disable time-based backlight control. When disabled the
backlight stays on permanently, otherwise the backlight will be switched
on and off at designated times. Backlight off means the display is off!
• Turn on backlight: Use next button to move between controlling hours or
minutes and use “+” and “-” buttons to changes the values.
• Turn off backlight: Use next button to move between controlling hours or
minutes and use “+” and “-” buttons to changes the values.
• Current brightness: Use “+” and “-” buttons to change brightness level,
indicated by the size of the yellow bar.
To Next Page
Loading...
