and year. On the right hand side, you will find the largest value ever seen
(since device installation or reset) for each of these values, along with date
and time that maximum value was observed.
5.8 Factory Mode
The “Factory” mode page can be entered from the normal mode by repeatedly
pressing the MENU key.
Use the GRAPH or TEMP button to move to the next, or previous, option
(indicated by a right arrow above the button). The selected option will be
highlighted in yellow. Press the RAIN button to change or activate the
selected option. In all cases you will next be asked if you want to proceed with
the chosen action, answering “Yes” or “No” by using the “next,” and
“previous” buttons to highlight (in yellow) the desired answer and press “+”
to select that answer.
The following options are available:
• Factory Reset: Any and all customization to settings, calibration and
historical data will be erased and reset to factory default values.
• Clear Max/Min: Removes all recorded maximum and minimum values
(for temperature in “section 5.5” and “other” in “section 5.6”)
• Re-register Indoor: Forces the console to forget which indoor sensor it is
receiving and then start “looking” for available sensors and “registering”
the first one found.
• Re-register Outdoor: Forces the console to forget which outdoor sensor it
is receiving and then start “looking” for available sensors and
“registering” the first one found. Both options should rarely be needed,
unless you have had to replace indoor or outdoor sensor(s) or in case of
troubleshooting
• About: Displays various technical information that may be useful to
troubleshooting or for communication of issues with customer service.
Press MENU to return to the “Factory” mode page.
• English: Displays the console’s language. Currently cannot be changed,
but future versions may allow choice of other languages.
To Next Page
Loading...
