AG45134 Rev. 3 2 - 17
PLATE WIDTH
OPTIONS 9.922” to 25.472” or 253.8 mm to
646.9 mm
By picking a value, you set the plate width for test patterns.
PLATE LENGTH
OPTIONS 9.992” to 36.574” or 253.8 mm to
928.9 mm
By picking a value, you set the plate length for test patterns.
PLATE IS NOTCH REGISTERED
OPTIONS YES or NO
By picking a selection, you set the alignment to be used for test
patterns. Punched plates are generally notch registered as
opposed to edge registered.
NOTCH DEPTH
OPTIONS 0.000” to 1.000” or 00.0 mm to 25.4
mm
By picking a value, you set the notch depth for test patterns.
DISTANCE FROM NOTCH TO LEADING EDGE
OPTIONS 2.125” to 36.574” or 53.9 mm to 928.9
mm
This options specifies the distance from the leading edge of the
plate to the center of the notch that is closest to the leading
edge. This parameter is only for notch-registered plates.
EXPOSURE LEVEL
LIMITS 000 to 255
This menu entry sets the exposure level at the media. The
higher the number, the higher the exposure.
To Next Page
Loading...