3 - 14 AG45134 Rev. 3
them again until the green LED stays on.Be careful to not apply
so much pressure to the plate that the registration pins dent the
plate. Use one finger/thumb to apply minimal pressure to the
center of the plate while lifting the plate slightly.
Note: If the green LED is not staying illuminated, the pin bar may
not be fully seated. Remove and reinstall the pin bar, fol-
lowing the instructions above.
Step 7. Holding the plate in position, lower the pinch roller bar. The green
light will remain on if pin contact has been maintained and the
recorder will prompt for the OK button to be pressed to start
imaging.
Note: If the green LED does not stay illuminated, open the pinch
roller bar and go back to Step 5.
Step 8. Press the OK button. The plate will be backed up to properly posi-
tion the leading edge for exposing.
Step 9. After the plate is imaged, it will automatically be transported out of
the platesetter and into the on-line processor.
To Next Page
Loading...