100
3
BIOS Setup
3.1.11 Set Supervisor Password
If you want to protect your system and setup from unauthorized
entry, set a supervisor’s password with the “System” option se-
lected in the Advanced BIOS Features. If you want to protect
access to setup only, but not your system, set a supervisor’s pass-
word with the “Setup” option selected in the Advanced BIOS
Features. You will not be prompted for a password when you
cold boot the system.
Use the arrow keys to highlight “Set Supervisor Password” and
press <Enter>.
Type in the password. You are limited to eight characters. When
done, the message below will appear:
Confirm Password:
You are asked to verify the password. Type in exactly the same
password. If you type in a wrong password, you will be prompted
to enter the correct password again. To delete or disable the
password function, highlight “Set Supervisor Password” and press
<Enter>, instead of typing in a new password. Press the <Esc>
key to return to the main menu.
To Next Page
Loading...
Need help?
General
