37
2
Hardware Installation
2.5.4 S/PDIF-in/out Jacks
The system board is equipped with an onboard S/PDIF-in RCA
jack (red) and a S/PDIF-out RCA jack (yellow) at locations CN5
and CN6 of the system board.
The S/PDIF connector at location J4 is for optical S/PDIF cable
connection. Connect the optical audio cable connector of your
S/PDIF module to J4. Make sure pin 1 of the audio cable connec-
tor is aligned with pin 1 of J4.
DO NOT use RCA S/PDIF and optical S/PDIF at the same time.
S/PDIF-in
W
S/PDIF-out
15
VCC
Key
SPDIF out
GND
SPDIF in
W
J4
To Next Page
Loading...
