62
3
BIOS Setup
The settings on the screen are for reference only. Your version may not be identical
to this one.
IDE HDD Auto Detection
Detects the parameters of the drive. The parameters will auto-
matically be shown on the screen.
IDE Channel 0 Master/Slave and IDE Channel 1 Master/Slave
The drive type information should be included in the documenta-
tion from your hard disk vendor. If you select ”Auto”, the BIOS
will auto-detect the HDD & CD-ROM drive at the POST stage
and show the IDE for the HDD & CD-ROM drive. If a hard disk
has not been installed, select “None”.
Access Mode
For hard drives larger than 528MB, you would typically select the
LBA type. Certain operating systems require that you select CHS
or Large. Please check your operating system’s manual or Help
desk on which one to select.
3.1.1.3 IDE Channel 0 Master, IDE Channel 0 Slave, IDE Channel 1
Master and IDE Channel 1 Slave
Move the cursor to the “IDE Channel 0 Master”, “IDE Channel 0
Slave”, “IDE Channel 1 Master” or “IDE Channel 1 Slave” field,
then press <Enter>.
To Next Page
Loading...
Need help?
General
