87
3
BIOS Setup
3.1.5.12 Resume On LAN
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the sys-
tem only through an IRQ or DMA interrupt. Refer to “Wake-On-
LAN Connector” in chapter 2 for more information.
3.1.5.13 USB KB Wake-Up From S3
This field, when enabled, allows you to use a USB keyboard to
wake up a system that is in the S3 (STR - Suspend To RAM)
state. This can be configured only if the “ACPI Suspend Type” field
is set to “S3(STR)”.
3.1.5.14 Resume By Alarm
Enabled When Enabled, you can set the date and time you
would like the Soft Power Down (Soft-Off) PC to
power-on in the “Date (of Month) Alarm” and “Time
(hh:mm:ss) Alarm” fields. However, if the system is
being accessed by incoming calls or the network
(Resume On Ring/LAN) prior to the date and time
set in these fields, the system will give priority to the
incoming calls or network.
Disabled Disables the automatic power-on function. (default)
3.1.5.15 Date (of Month) Alarm
0 The system will power-on everyday according to the
time set in the “Time (hh:mm:ss) Alarm” field.
1-31 Select a date you would like the system to power-
on. The system will power-on on the set date, and
time set in the “Time (hh:mm:ss) Alarm” field.
To Next Page
Loading...
Need help?
General
