98
3
BIOS Setup
Restoring a Configuration
To restore one of the previously saved configurations, move the
cursor to “Load” of “User Define Config 1” then press <Enter>.
The message below will appear.
Renaming a Configuration
The default name given in the “User Define Config 1” field is
“Config 1” and “Config 2” in the “User Define Config 2” field. To
rename, move the cursor to “Rename” then press <Enter>. The
message below will appear. You can enter up to 16 characters.
To save another configuration, repeat the procedures above but
this time, in the “User Define Config 2” field.
To Next Page
Loading...
