Cadence II Fetal Monitor Service Manual
- 7 -
Chapter 1 Overview
1.1 Product Information
CADENCE Ⅱ provides accurate and reliable monitoring information, using non-invasive
ultrasound Doppler, external TOCO technique.
RS-485/RS-232 communication port is built, the monitor can be connected with
MFM-CNS central monitoring system via this port. The monitor can be connected to
wireless network module via a DB9 interface, and the wireless network module will
complete the data switch of the monitor and the MFM-CNS central monitoring system.
The data collected and stored by the CADENCE Ⅱ Fetal Monitor can be analyzed and
printed by the CADENCE Insight software running on PC or MFM-CNS Obstetrical
Central Monitoring System (CareVista) (Refer to MFM-CNS Obstetrical Central
Monitoring System (CareVista) User Manual and the relevant information of wireless
network module).
CADENCE adopts 5.7Ⅱ " LCD, and the collected data, trends, and monitoring
parameters are displayed at the same screen. A built-in thermal recorder is used to
record the monitoring information.
1.2 Technical Specifications
(1) Safety
The CADENCE Ⅱ Fetal Monitor is designed to comply with the international safety
requirements IEC 60601-1 for medical electrical equipment. It is class I equipment.
(2) Size and Weight
Size (Monitor) 330 (L) x 270 (W) x 100 (H) mm
Weight (Monitor) About 3.5 kg
(3) Environment
Working
Temperature: 5℃-40℃
Humidity: < 80%
Atmospheric Pressure: 86kPa-106kPa
Transport and Storage
Temperature: -20℃-55℃
Humidity: < 93%
Atmospheric Pressure: 86kPa-106kPa
Power Supply: 100-240V AC, 50/60Hz
Pmax = 60VA